Showing 161–200 of 324 results

KNIPEX Standard Combination Plier

  • Powerful gripping, bending & pulling
  • 35% greater leverage than standard pliers of the same length
  • Suitable for cutting all common wire types

KNIPEX Wire Cutter – Scalloped Jaw

  • Induction-hardened precision cutting edges.
  • Cutting edge hardness approximately 64HRc.
  • Features Scalloped Jaw for improved cutting performance

KNIPEX Wire Cutter – Straight Jaw

  • Induction-hardened precision cutting edges.
  • Traditional Straight Jaw design
  • Ergonomically styled handles

KV LED Tester

  • Self-earthing fence tester with bright LED display
  • Reads up to 10kV
  • Runs on 2 x CR2016 batteries

Lightning Arrestor

  • Protects mains fence energizer from lightning
  • Channels lighting to ground to minimise damage to the energiser.

LIGHTNING Diverting Arrestor/Choke Kit

  • Proven In harsh Australian Lightning Conditions
  • Porcelain diverter
  • Joint clamps and heavy duty choke spring

Low Voltage Alarm Indicator

  • Flashes to indicate fence has dropped in voltage below 2000
  • Flashes red when Voltage below the correct level (2 settings).
  • Easily attaches to your electric fencing wire, braid or tape
  • Runs on 1 x CR2016 battery

The Strainrite Low Voltage Alarm Indicator is an invaluable ‘alarm’ for showing when there has been a drop in the voltage through the fence.

This small, lightweight unit simply clips into the fence line and the red light will flash if the voltage drops below the correct level (2 settings). It also serves to remind you, from a distance, whether the fence is on or not.

It has an off switch, and a high and low switch depending on the type of fence it is monitoring. We recommend using the low setting for any electric netting and polywire, and the high setting for others such as tape or galvanised wire.

The Low Voltage Alarm which starts flashing when the voltage drops below 2000 (As opposed to the Clip-on Indicator Flasher flashes a green light with each pulse and stops flashing when fence voltage drops below 3000 volts).

Tip: Hang it near to where the power goes into the fence. Works best on tape or rope. For Electric Netting we recommend the Indicator Light Tube

M-STOP 1m Outrigger 10 Pack

Available in packs of 10

MPI Recommended Buffer
Manufactured to MPI’s guidelines for on-farm, biosecurity protection. Providing a cost-effective, permanent fixing, 1m offset outrigger to create a 2m buffer zone. (1m either side of a fence line)

Undulated Ground Strut Bracing
We recommend using Strainrite Bayco Wire for strut bracing to deal with the undulating ground when the wire pulls the outrigger up or down. The struts can be tied off using a 5mm Strainrite Crimps and stapled to the post. The Bayco wire also acts as an insulator further preventing any potential arcing out.
(Bayco Insul-tie 5 Pack Part Number FCA00011)

NZ Made & Built Tough
Dura-tip eliminates wear from wire movement. High strength shaft is manufactured from 7mm galvanised spring steel.

MPI guidelines: Protect your farm from Mycoplasma Bovis
You can view the MPI guidelines by going directly to their website:
https://www.mpi.govt.nz/dmsdocument/19148/loggedIn

 

Max Power Plus Polytape 200M Orange

  • Tape Width 12mm
  • Six 0.22mm diameter durable stainless steel wires
  • Carriers four times the power of Max Power Std Tape
  • Highly visible
  • 2500 ohms

Max Power Plus Polytape 200M White

  • Tape Width 12mm
  • Six 0.22mm diameter durable stainless steel wires
  • Carriers four times the power of Max Power Std Tape
  • Highly visible
  • 2500 ohms

Max Power Plus Polytape 400M White

  • Tape Width 12mm
  • Six 0.22mm diameter durable stainless steel wires
  • Carriers four times the power of Max Power Std Tape
  • Highly visible
  • 2500 ohms

Max Power Polytape Standard 200M Orange

  • Tape Width 12mm
  • Six 0.22mm diameter durable stainless steel wires
  • Carriers four times the power of Max Power Std Tape
  • Highly visible
  • 2500 ohms

Max Power Polytape Standard 200M White

  • Tape Width 10mm
  • Six 0.15mm diameter durable stainless steel wires
  • High conductivity and UV stabilized.
  • Highly visible

Max Power Polytape Standard 400M Orange

  • Tape Width 11mm
  • Six 0.15mm diameter durable stainless steel wires
  • High conductivity and UV stabilised.
  • Highly visible

Max Power Polytape Standard 400M White

  • Tape Width 10mm
  • Six 0.15mm diameter durable stainless steel wires
  • High conductivity and UV stabilised.
  • Highly visible

Mega Claw Black 25 Pack

  • Extended Jaws suitable for coated sighter wire, poly rope, or braid.
  • High-performance standard insulator
  • Rounded surfaces that shed water faster.
  • Long-life UV stabilised plastic.
  • Proudly designed and manufactured in NZ.
  • 12 Year Guarantee.
  • Colour: Black

Mega Claw White Insulator 25 Pack

  • Extended Jaws suitable for coated sighter wire, poly rope, or braid.
  • High-performance standard insulator
  • Rounded surfaces that shed water faster.
  • Long-life UV stabilised plastic.
  • Proudly designed and manufactured in NZ.
  • 12 Year Guarantee.
  • Colour White

Mild Steel Skid Mutton / Swivel Hook Assembly

  • Available in both Mild Steel and Stainless Steel Options
  • 25mm wide x 6mm thick
  • Lengths May Vary

Multi Jumper Lead Connector

  • Insulated Silicone Coating
  • Stainless Steel Spring & Jaw
  • Easy wire attachment for easy termination

Multiwire Treadin Post – Red – Box of 50

  • Unique angled clip prevents unintentional tape detachment
  • 4 position level options for 40mm/1 1/2″ tape
  • 8 positions for Polywire, Polytape & Braid
  • Overall Length 1100mm – Length from base of foot 915mm
  • Box of 50

Multiwire Treadin Post – White – Box of 50

  • Unique angled clip prevents unintentional tape detachment
  • 4 position level options for 40mm/1 1/2″ tape
  • 8 positions for Polywire, Polytape & Braid
  • Overall Length 1100mm – Length from base of foot 915mm
  • Box of 50

Multiwire Treadin Post – Yellow – Box of 50

  • Unique angled clip prevents unintentional tape detachment
  • 4 position level options for 40mm/1 1/2″ tape
  • 8 positions for Polywire, Polytape & Braid
  • Overall Length 1100mm – Length from base of foot 915mm
  • Box of 50

MX160 Mains 20km Energizer

A compact 230/240v plug-in single output energizer

  • 230/240v mains input
  • Pulse Indicator
  • Tough weatherproof sealed enclosure
  • 1.6 Stored Joules
  • 1.4 Output Joules
  • 9.0kV Max Voltage
  • 7 ha (17 acres) Coverage

Mains Energizer Guide

Safety Advice

MX320 Mainspower Energizer 30km

A compact 230/240v plug-in single output energizer

  • 230/240v mains input
  • Pulse Indicator
  • Tough weatherproof sealed enclosure
  • 3.2 Stored Joules
  • 2.25 Output Joules
  • 9.6kV Max Voltage
  • 7 ha (17 acres) Coverage

Mains Energizer Guide

Safety Advice

MX600 Mains 40km Energizer

High output main energizer with dual high/low output and fence efficiency indicator.

  • 230/240v mains input
  • Wall mount
  • Dual Output High/Low
  • Fence load LED indicator
  • Tough weatherproof sealed enclosure
  • 5.7 Stored Joules
  • 4.2 Output Joules
  • 9.5kV Max Voltage

Coverage

  • 16ha /40 acres
  • 40km

Mains Energizer Guide

Safety Advice

MX80 Mains 8km Energizer

A compact 230/240v plug in single output energizer

  • 230/240v mains input
  • Pulse Indicator
  • Tough weatherproof sealed enclosure
  • 0.8 Stored Joules
  • 0.45 Output Joules
  • 7.5kV Max Voltage
  • 3 hectares / 8 Acres

MXB240 Unipower 12km Energizer

Run on either 12v battery or mains power supply allowing for flexibility when you need it.

  • 12v DC Battery Input Voltage
  • 230v AC Mains Input Voltage
  • Lower battery pulse indicator
  • Weatherproof enclosure
  • 1.2 Output Joules
  • 2.4 Stored Joules

FEN00260 MXB240 Instructions

Safety Advice

Netting Clip Pliers

  • Special pliers with groove to hold all netting clips
  • PVC coated handles for comfort
  • 16mm medium clips

Outrigger With Jouleshield Steel Post Pinlock Insulator – Box of 50

  • Range 2 Spring Steel Wire.
  • Positively located both horizontally and vertically.
  • Length off fence 300mm
  • Attaches simply to existing fencing.

Outrigger With White Porcelain Round Insulator – Box of 50

  • Attach electric wire onto an existing fence.
  • Simply attaches to existing fencing.
  • Prolongs the life of an old fence

Permanent 4 Arm & Adjustable 3 Arm Jenny Spike

  • As supplied with FWJ00160 & FWJ00155
  • Standard Jenny Spike
  • 19mm Diameter Shaft
  • Overall Length of 490mm
  • The length between brake washer & ground washer 100mm

Permanent 4 Arm Wire Jenny

  • Self-Regulating Friction Hub to prevent wire overrun
  • Convenient handle for re-coiling used wire
  • Designed for a standard 25kg coil of wire
  • Complete with Ground Spike
  • Stand available as an alternative – Sold Seperately

Pigtail Post 6mmx1040mm – Bundle of 10

  • Galvanised pressed formed foot
  • 6mm x 1040mm Shaft
  • Quality UV Stabilized Insulator
  • Out Of Ground Height 850mm
  • Superior Ground Holding
  • Bundle of 10

Porcelain Bullnose Insulator – Single Unit

  • Robust Long-life, porcelain insulator
  • Fire resistant – Used Widely in Australian Fencing
  • Ideal for extreme heat conditions

Post Driver – 100mm

  • Improved service life
  • Reduced transfer of shock back the handles of your hands
  • Inside diameter 100mm nominal

Post Driver – 150mm

  • Improved service life
  • Reduced transfer of shock back the handles of your hands
  • Inside diameter 150mm nominal

Post Driver – 200mm

  • Improved service life
  • Reduced transfer of shock back the handles of your hands
  • Inside diameter 200mm nominal

Made to order Only – 3 weeks lead time

Post Hole Auger/Borer

  • Rugged Steel Construction
  • Easily sharpened with a file
  • 100mm to 250mm diameter options available
  • Height 1100mm
  • Handle Length 600mm
  • Handle Diameter 25.4mm
  • Tube Thickness 2mm

Post Hole Rammer

  • Compaction made easy!
  • Special post contoured cast iron foot
  • Handle Length 1630mm galvanized and capped handle.
  • 25mm Dia x 2mm wall

Post Hole Rammer Foot Only

  • Replacement Foot for the Post Hole Rammer – FPR00200
  • Special post contoured cast iron foot